These design parameters define the thermal requirements for your cooling tower. Please use the question marks for assistance with these input parameters.
Water Flow Rate (°C)

Quantity of hot water entering the tower measured in gallons per minute

Relative Humidity (%)

Percentage of saturated air


Hot Water Temp (°C)

Temperature of circulating water entering the tower measured in degrees farenheit

Site Elevation (m)

Level at the tower location


Cold Water Temp (°C)

Temperature of circulating water exiting the tower, measured in degrees farenheit

Total Dissolved Solids (g/kg)

Amount of dissolved solids present in the circulating water measured in grams per kilogram: use 5 for fresh water and 30 for salt water.


Wet Bulb Temp (°C)

Temperature of inlet saturated air

Fill Assembly
Assembled
Nested

Select "Nested" if you wish to assemble the fill onsite (typical only for overseas shipment).


DE Type

Standard = 0.005% Drift Loss
Low Drift = 0.001% Drift Loss

Fill Type

Utilize High Performance film fill for most applications with normal water conditions.
Utilize Low Fouling fill if suspended solids are high or process water is prone to fouling.
Select Splash fill for poor water quality.


Evaluation parameters allow DEPOT to estimate evaluated costs for your cooling tower. Evaluated costs include the costs of ongoing operation of electric fan motors and electric water pumps as well as the cost of wiring/installation of control room equipment.
Fan Power ($/kW)

Cost in dollars/kilowatt of the parasitic load associated with operating the fan motors

Pump Efficiency (%)

Efficiency of the circulating water pumps expressed as a percentage.

Use 85% for standard efficiency


Basin ($/m2)

Cost of concrete basin installation, measured in dollars/ft2

Pump Head Unit (m)
$/foot $/kW

Units used in evaluation of the cost of operating electric pump for circulating water


Electrical ($/cell)

Initial one time cost of switch gear and wiring for the electric fan motors in dollars per cell

Pump Head

Cost of operating electric pump for circulating water


Material choices directly impact both the cost and longevity of a cooling tower. On this page, changing the structural material will make automatic changes to certain other inputs. Feel free to customize the materials in any part of your cooling tower.
Structural Material

FIXME: Tip here?

Hardware Material

FIXME: Tip here?


Fan Deck Material

FIXME: Tip here?

Stairway Material

FIXME: Tip here?


Casing Material

FIXME: Tip here?

Ladder Material

FIXME: Tip here?


Partition Wall Material

FIXME: Tip here?

Fanstack Material

FIXME: Tip here?


Wind Wall Material

FIXME: Tip here?


The Dimensional Limits you choose have a major impact on the run time of the DEPOT program. DEPOT sets appropriate values as defaults based on the table below. If you wish to decrease DEPOT run time, reduce the difference between the minimum and maximum number of cells. Please keep in mind that this will reduce the number of towers DEPOT calculates and therefore diminish DEPOT's ability to optimize your cooling tower design.
Maximum 
Minimum

No. of Cells

Cell Length x Width

Tower Length

Tower Width

No Stairways:

No Ladders:
The Dimensional Limits you choose have a major impact on the run time of the DEPOT program. DEPOT sets appropriate values as defaults based on the table below. If you wish to decrease DEPOT run time, reduce the difference between the minimum and maximum number of cells. Please keep in mind that this will reduce the number of towers DEPOT calculates and therefore diminish DEPOT's ability to optimize your cooling tower design.
Air Inlet Scheme
1 Side Only
2 Sides Only
2 Sides One End
2 Sides, 2 Ends
 

Tower Configuration
Inline
Back to Back