These design parameters define the thermal requirements for your cooling tower. Please use the question marks for assistance with these input parameters.
Water Flow Rate (°C)
Quantity of hot water entering the tower measured in gallons per minute
Relative Humidity (%)
Percentage of saturated air
Hot Water Temp (°C)
Temperature of circulating water entering the tower measured in degrees farenheit
Site Elevation (m)
Level at the tower location
Cold Water Temp (°C)
Temperature of circulating water exiting the tower, measured in degrees farenheit
Total Dissolved Solids (g/kg)
Amount of dissolved solids present in the circulating water measured in grams per kilogram: use 5 for fresh water and 30 for salt water.
Wet Bulb Temp (°C)
Temperature of inlet saturated air
Fill Assembly
Assembled
Nested
Select "Nested" if you wish to assemble the fill onsite (typical only for overseas shipment).
DE Type
Standard = 0.005% Drift Loss Low Drift = 0.001% Drift Loss
Fill Type
Utilize High Performance film fill for most applications with normal water conditions. Utilize Low Fouling fill if suspended solids are high or process water is prone to fouling. Select Splash fill for poor water quality.